Publicidad
Idiomas disponibles
Idiomas disponibles
Please consider the respective national norms during the installation! The installation must only be carried out by an
authorized employee or dealers!
This fixture has been designed to be hung. It is recommended for safety purposes, your lighting effect are properly mounted using a suitable
hanging clamp and safety cable. Items appropriate for safe and effective mounting are easily sourced from your lighting vendor.
International laser safety regulations require that lasers must be operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of
vertical separation between the floor and the lowest laser light vertically. Additionally, 2.5 meters of horizontal separation is required between laser
light and audience or other public spaces.
Use of controls, adjustments, or performance of procedures other than what is specified herein may result in hazardous
radiation
exposure!
The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without any harming
deformation.
Always use the supplied mounting bracket to hang the fixture.
The fixture should aid of a mounting bracket (not included) to the supplied mounting bracket to be confirmed.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary safety
attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before taking into
operation for the first time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
The fixture should be installed in the position where persons cannot reach.
For your own safety and for others, we do strongly recommend you to use this laser emergency kill
switch. (ref.no: 152.958)
When installing the device, make sure there is no highly in inflammable material (decoration articles, etc.) in between a
distance of min 0.5 meter.
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product
must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and
may be used. No dimmer or adjustable power supply.
The unit has a powerconnector output on board. Depending on the local conditions several units can be linked by powerconnector in- and output.
Connect a maximum of four (when using 230V/16A) units in a row. Use an approved three-core cable with a cross-section of at least 1.5 mm². The
installation instructions of the manufacturer and the colour coding of the cable must be observed. Do not turn off the unit by turning the
powerconnector but use the power on/off switch or schuko!
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
Publicidad
