HAEGER Ultra Warm GH-42B.005A Instrucciones De Uso página 14

Troubleshooting guide
The heater doesn't light:
• Check the gas cylinder if it is full
• Check the regulator if it is properly attached and the cylinder valve is turned on.
• Check if the instructions have been followed correctly.
The heat doesn't light after the cylinder has been changed it could be due to:
• There is some air present in the cylinder, hold the control knob down for a longer
period of time until the pilot and main burner light. Switch to the 3 High setting.
• The cylinder may have been excessively cold. Allow the cylinder to reach room
temperature before attempting to start the heater.
The heater turns off by itself:
• If the heater goes out on continuous working, repeat the operation, following the
instruction.
• If it goes out soon after lighting, check for drafts or for the gas cylinder running out
of gas.
• If it goes out after 30 minutes or so, it is signaling that it is operating in a badly
ventilated area. Open a window or door to ventilate the area and reignite.
• Avoid bumping the heater in operation. Don't move the heater while in operation.
Technical Data
Model: ..............................................................................................................GH-42B.005A
Category: ........................................................................................................ I3+ (28-30/37)
Burner type: ................................................................................................. Ceramic burner
Gas Type: ................................................................................. Butane (G30), Propane (G31)
Pressure: ............................................................ Butane at 28-20mbar, Propane at 37mbar
Injector size: ............................................................................................................. 0,59mm
Countries of Destination: ....................... BE, FR, IT, LU, LV, GR, PT, ES, CY, CZ, LT, SK, CH, SI
Total heat input (ΣQn): ......................................................... 4.2 kW (consumption 305 g/h)
Nominal medium heat input: ............................................... 2.9 kW (consumption 210 g/h)
Nominal minimum heat input: ............................................. 1.5 kW (consumption 109 g/h)
Ignition system: ................................................................................................ Piezo ignition
Gas container: ...................................................................................................... up to 15kg
P.I.N Code: ....................................................................................................... 2531CS-0008
Dimensions: .......................................................................................... 420 x 290 x 720 mm
Net / Gross Weight: ........................................................................................... 7.8 kg / 9 kg
12