cecotec CONGA POPSTAR 3000 CARPET CLEAN Manual De Instrucciones página 25

ENGLISH
- Make sure all parts and components are included and in good conditions. If any sign of
visible damage is observed, immediately contact Cecotec's official Technical Support
Service.
Box contents:
- Upholstery cleaner
- Right-angle suction nozzle
- Water suction nozzle with brush
- Clean-water tank
- Waste-water tank
- Hose hook
- Water tank cap
- Instruction manual
3. ASSEMBLY
Insert the hose hook (6) in the device (4). Fig. 3
1.
2. Remove the clean-water tank (3) from the main body of the device (4). To do so, slide the
clean-water tank release tab (2) and remove the tank (3) in the direction of the arrow
shown in figure 4.
Turn the clean-water tank (3), loosen the cap, and fill the tank with clean water. The
3.
maximum water capacity is 1.2 litres approximately and it is marked in the tank with 'MAX'.
Fig. 5
4. Install the clean-water tank (3) again in the main body of the device (4). Fig. 6
Insert the hose bracket (8) in the suction nozzle (A/B). The holes on both pieces must
5.
match during assembly. Fig. 7
Warning
- After filling the tank with water (3), you must tighten the cap correctly to avoid leakage.
- You can add low-foam detergent to the clean-water tank (3), combined with water in a
5:10 proportion.
- After using your device, you must empty the remaining water in the clean-water tank (3) to
avoid leakage and mould formation.
- Do not shake the clean-water tank (3) during installation, as it could cause water leakage.
48
4. OPERATION
1. Plug the device into a power supply. Fig. 8
2. Press the power button (1) to turn the device on. Fig. 9
3. Hold down the water release button (7) to spray clean water (Fig. 10). Spray clean water
over the dirt to bring it to the surface.
4. Press the vacuuming inlet (18) on the dirt to bring water and dirt to the surface and
vacuum them. Fig. 11
5. Stop spraying clean water and vacuum the waste water (Fig. 12). After using the device,
dry the surface with a dryer or let it air dry.
6. Switch off the device by pressing the power button. Fig. 13
7. Disconnect the device from the power supply.
8. Empty the clean and waste water from the tanks and clean the waste-water tank.
Warning
- Do not spray water continuously over the same spot.
- Take special care when using the device to clean stairs.
- After using the device, hang and wind the power cord in the power cord holder.
Cleaning embedded dirt
Warning:
- You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
- Make sure the detergent will not damage the soiled surface before using it.
- Do not use thinners, aniline, chloroform or flammable detergents.
Recommended liquids
- Alkaline ionised water.
- Low-foam detergent to the clean water tank combined with water in a 5:10 proportion.
- Citric acid
- Water with hydrochloric acid.
Non-recommended liquids
- Neutral kitchen detergent.
- Alkaline detergent.
- Acid detergent.
Apply detergent over the soiled surface, spray clean water and scrub the dirt with a brush
1.
(19) to bring it to the surface.
2. Vacuum the dirt and do not let any detergent remain. Fig. 14
ENGLISH
CONGA POPSTAR 3000 CARPETCLEAN 49