cecotec CONGA ROCKSTAR NONSTOP FLEX Manual De Instrucciones página 25

ENGLISH
4. OPERATION
You can use this vacuum cleaner in two different manners:
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
-
Using the vacuum cleaner
- Press the power button to turn the vacuum cleaner on or off.
Press the speed dial repeatedly to select the device's operating speed: Eco and Turbo. The
-
device will turn on in Eco mode by default.
Attachments
This device includes different accessories that allow cleaning different types of surfaces,
objects, and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush
Install this accessory on the suction base and the latter to the upright vacuum cleaner. This
brush is especially designed for cleaning hard floors, but can be used to efficiently clean soft
floors too.
2 in 1 accessory
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it.
Accessory for corners
This accessory is preferably used with the handheld vacuum cleaner to reach less accessible
dirt in corners.
Articulated vacuuming tube
Use the articulated tube to reach and vacuum dirt from the most inaccessible zones. Press the
button to bend the tube.
Installing the wall bracket Fig. 4
1. Place the bracket on the wall and mark 3 spots to be drilled to fix the bracket. You must
take into account the height of the installation; it is important that vacuuming brush head
rests on the floor to prevent the wall bracket from supporting all the vacuum cleaner's
weight.
2. Drill the 3 holes (previously marked) and insert the pegs and screws.
3. Make sure the bracket is securely fixed to the wall and place the vacuum cleaner on it,
inserting its charging terminals into the bracket's.
48
CONGA ROCKSTAR NONSTOP FLEX
4. Once the wall bracket is installed, connect the power adapter to the charging port, and
then you can charge the vacuum cleaner by simply sliding it up and down the wall bracket.
Charge and display
- The battery must be charged with the wall bracket while it is connected to the main body.
Connect one of the ends of the power adapter to the power supply and the other to the
charging base.
During charge, the battery indicator will flash. When charging is complete, the battery
-
indicator will remain steady.
- You can also charge the battery without using the wall bracket. You can charge the battery
when the battery is installed or not in the vacuum cleaner. Connect the adapter and connect
the other end to the battery, paying attention to the direction. Once properly connected,
the battery indicator will flash and change to steady when charging is complete.
5. CLEANING AND MAINTENANCE
Always turn off and unplug the vacuum cleaner before cleaning or maintenance.
-
- Use a soft, slightly dampened cloth to clean the device's surface.
- Never immerse the device in water or other liquids. Do not allow liquids to enter the device.
Do not use abrasive cleaners or scouring pads to clean the product.
-
Do not leave the vacuum cleaner in a place with direct sunlight.
-
- Do not leave the vacuum cleaner in a wet place after cleaning it.
- After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it for it to operate correctly again.
Filters and tank cleaning
- To prevent the appliance from overheating and losing suction power, it is suggested to
clean the filters frequently. To make the most of the suction power, it is suggested to clean
the filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which are
frequently vacuumed. It is recommended to replace the filters every 6 months.
To remove the main filter:
1. Press the dirt-tank and filter access release buttons, turn clockwise to remove the filter
system.
2. Once the filtering system is out, turn the metallic handle anticlockwise and you will be
able to take the high-efficiency filters out.
To remove the upper filter:
1. Turn the top cover counterclockwise.
Remove the fabric filter.
2.
ENGLISH
49
CONGA ROCKSTAR NONSTOP FLEX