Beta 5000 RSC50/PLED Manual De Instrucciones página 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
B) Remote control mode:
1. Connect the connection cables as shown in the figure below.
2. The power supply unit can handle up to three LED strips. The first item to be connected is one of the supplied cables, followed
by the remote control receiver (LED side towards the LED strips) and then the LED strips.
3. All connected LED strips have no switch.
4. Press the buttons on the remote control to switch on/off or adjust the brightness of the LED strip.
Note: The device keeps the status memory (on-off and intensity) so if the 230V power supply is switched off, the previous status
is restored when the device is switched on again.
REMOTE CONTROL
Functions:
Button 1: Light on/Standby:
Pressing the button switches the light on or switches to standby mode (light off).
Button 2: 100% lighting mode.
Button 3: 50% lighting mode.
Button 4: 25% lighting mode.
Button 5: Press BRIGHT + to increase brightness.
Button 6: Press BRIGHT - to decrease brightness.
8
Power supply
Connection cable 1
LED strip without switch
Connection cable 2
LED strip without switch
Connection cable 3
LED strip without switch
AC220~240V
Input
EN I