Beta 5000 RSC50/PLED Manual De Instrucciones página 7

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
TECHNICAL DATA
POWER SUPPLY SECTION
POWER SUPPLY INPUT VOLTAGE
POWER SUPPLY OUTPUT
LED STRIP SECTION
LED WATT
LIGHT OUTPUT
LED COLOUR TEMPERATURE
BRIGHTNESS LEVEL
REMOTE CONTROL SECTION
REMOTE CONTROL OPERATING VOLTAGE
REMOTE CONTROL MODE
TRANSMISSION FREQUENCY
REMOTE DISTANCE
USE
Mode A) Touch-controlled switch:
1. Connect the connection cables as shown in the figure below.
2. The power supply can control up to three LED strips, the first of which has a switch that also controls the subsequent strips. The
side with the switch of the first strip must be connected directly to the control unit with one of the supplied cables.
3. In the case of lamps with independent ignitions, a ballast must be connected for each lamp.
4. Connect the AC plug to the power outlet.
5. Touch the touch switch to switch the light on or off.
6. When the light is on, press and hold the switch to adjust the brightness (dimmer).
Note: The device keeps the status memory (on-off and intensity) so if the 230V power supply is switched off, the previous status
is restored when the device is switched on again.
AC220~240V
Input
LED strip with switch
LED strip without switch
LED strip without switch
AC 220 - 240V 50Hz
DC 24V 0.8A
6.5W per LED strip
500 lm per LED strip
4000K
[Touch control switch] 10 to 100 % (Dimmer)
[Remote control] 10 levels
Button cell battery CR 2025 - 3V
RF Wireless
433.92MHz
10 m. in open space
Switch
Connection cable 1
Connection cable 2
Connection cable 3
Power supply
EN I
7