Publicidad
Idiomas disponibles
Idiomas disponibles
5. Loosen the nut for the cable gland → pull out the
cable.
7. Remove the nut and pull out the cable gland.
NOTE: Components may have been removed for image clarity.
9. Unscrew the blind plug provided in the rear.
Date
ALL INFORMATION WITHIN ABOVE
BORDER TO BE PRINTED EXACTLY
29NOV22
AS SHOWN ON 8.5 x 11 WHITE 16
13DEC22
POUND NON-BOND RECYCLABLE
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
22MAR23
UNITED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
Revision
Third Re l
Fourth Re l
Fifth Re l
6. Change the position of the white switch carefully as
illustrated. A small screwdriver is required.
NOTE: failing to do this will produce an error.
NOTE: Components may have been removed for image clarity.
8. Insert the blind plug included with the accessory kit
into the opening for the cable gland from the bot-
tom. Secure it with the nut (from Step 1) and tighten
it to 131 ft/lbs(13 Nm).
Refit the cable clamp assembly (from Step 4) to the
remaining cable.
NOTE: Components may have been removed for image clarity.
10. Make sure a suitable 1" water tight conduit com-
pliant to type 4X and an adapter is used to fit the
1.3 in (33.7 mm) aperture shown → Push the new
(round) cable through the aperture.
NOTE: Components may have been removed for image clarity.
84922762
PART No.
R 22MAR23
Auth
DR
Title
SAR
AH
SAR
MB
PART No.
SAR
MB
Make sure the
adapter does not
protrude to the rear
of the unit so that
it will interfere with
wall mounting.
SHEET
Ultium PowerUP Charge Station
User Manual
SHEET
EN
10
Publicidad
