Publicidad
A
B
C
42
4-22
5-22a
Layout
4.5
Stop brake
Figure 4-22 Pedal of wheel stop brake
Activate the pedal to brake the wheel holder chuck
and make fixing nut clamping or unclamping easier.
The wheel is also retained in the correct position to
allow for an easier weight application.
Warning:
This stop brake is designed only to facilitate
orientation of the wheel and must not be used for
braking the chuck during operation.
The pedal also controls the Power Clamp, for clamping
the wheel on the balancer.
Lift the pedal so as to clamp or unclamp the wheel.
Press the pedal to engage the brake and stop the
chuck.
4.6
Clamping a wheel
Fig. 5-22a
The main shaft lock pedal has two functions:
A
PEDAL DOWN: Stopping rotation.
PEDAL UP:
POWER CLAMP lock
The pedal in addition to the brake has a control function
for the POWER CLAMP device, for clamping and
removing the wheel on/from the balancer.
Each time the pedal is moved UP, the Power Clamp
alternatively releases or clamps the wheel on the
balancer.
B
Power Clamp with jaws fully open.
C
Power Clamp with jaws fully closed.
Publicidad
