Deltaco Gaming GAM-103-W Manual Del Usuario página 10

Connect to
"Windows/Android/iPhone"
You can connect in 2 similar ways with
wireless. Either with X or with Y
button. X uses Xinput (a system API).
For Android, we recommend Y button
connection. For PC and iPhone we
recommend X button connection.
If you have connected an iPhone with
Y, games will not respond. Try again
with X button connection.
The controller will show up with
different names in the Bluetooth
settings depending on which button
you pressed.
Wireless (X connection): Xinput.
Press the connection button (20) + X.
LED 1 and LED 4 will start flashing.
From the Bluetooth settings, you can
now connect to this controller.
Wireless (Y connection): Press the
connection button (20) + Y.
LED 2 and LED 3 will start flashing.
From the Bluetooth settings, you can
now connect to this controller.
Wired: Connect controller to a device
with a USB cable.
LED 1 and LED 4 stays lit.
Windows only: The controller defaults
to XInput.
In XInput, "A" becomes "B", "B"
becomes "A", "X" becomes "Y" and "Y"
becomes "X".
Compatible with windows 10 or higher.
Turbo
Turbo works on these buttons: A B X Y
L R ZR ZL
1. Activate turbo: Press turbo button +
button that you want turbo on.
2. Activate automatic turbo: Press
turbo button + on the button that
already has activated turbo.
3. Turn off turbo: Press turbo + on the
button that has automatic turbo
activated.
Sleep mode
1. When the console's screen powers
off, the controller will enter sleep
mode.
2. While connected, the controller will
automatically enter sleep mode after 5
minutes of inactivity.
Reconnect
To reconnect press and hold the
"Home"-button for about 2 seconds to
wake up the controller and reconnect.
The controller will stay in sleep mode if
it can't reconnect within 10 seconds.
Charging
To charge: Connect a USB cable to
the controller and to a USB power
supply. For example, a USB power
adapter or a computer.
The LEDs flash when charging. They
flash differently depending on status.
LED 1 and 4 will flash if it is connected
with X (xinput)
LED 2 and 3 will flash if it is connected
with Y. LED 2 and 3 will flash when it
is off.
If you charge with a USB power
adapter LED 1, 2, 3 and 4 will flash
and turn off when fully charged.
1