Level One IGP-1061 Guía De Instalación Rápida página 4

Perform Initial Configuration (For model with console port)
1. Connect a PC to the switch console port using the included console cable.
2. Configure the PC's serial port: 38400 bps, 8 characters, no parity, one stop bit, 8 data bits, and no
flow control.
3. Log in to the CLI using default settings: Username "admin" and password "admin."
Note: For further information on switch configuration, refer to the Web Management Guide
and CLI Reference Guide.
Logging on to the equipment
1. Connect the RJ-45 interface cable of a switch with a computer using a network cable.
2. Set the TCP/IP properties of the computer, see the Appendix: Setting up your computer.
3. Logging on to the equipment: Open a browser and type 192.168.1.1 in the address bar, and then press
Enter; in the pop-up login interface, enter the factory logon username "admin", password "admin"
and click OK.
- 3 -