Publicidad
Idiomas disponibles
Idiomas disponibles
PLUG-IN ASSEMBLY INSTRUCTIONS
1a.
Determine the approximate location for the
wall sconce. Place the back plate (B) against
the wall and mark the location of the holes on
the back plate (B) using a pencil or a marker
(not included). Set back plate (B) aside.
Then, using a 1/8 in. drill bit (not included), drill
two pilot holes at the marked locations. Gently
tap wall anchors (DD) into holes with a
hammer (not included) until flush with wall
surface.
1b.
Use a level (not included) to adjust ears on
mounting plate (C) parallel with floor and
ceiling as needed. Secure back plate (B) and
mounting plate (C) to wall with wall anchor
screws (CC).
Hardware Used
Wall Anchor Screw
CC
Wall Anchor
DD
Attach fixture (A) to mounting plate (C) using
2.
the mounting plate screws (D) previously
removed (Step 3, Page 5).
NOTE: Fixture (A) can be installed with the
socket facing either up or down.
1a
1b
CC
x 2
CC
x 2
2
6
Pilot holes
Wall
B
C
Ear
B
Wall
D
A
D
DD
DD
DD
DD
Outlet
Box
C
Publicidad
