Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
QUICK INSTALLATION GUIDE
Step 1 prepairing the power supply
1. Make sure that the power switch of the unit is set to the "0" position (off) in the rear pannel.
2. Connect the socket of the included power cord to the [AC IN] jack on the rear pannel.
3. Plug the power cord into a power outlet.
Step 2 Making Connections
1. Turn all the knobs and [GAIN] knobs completely down.
2. Connect the microphones, instruments or speakers you inteed to use.
Step 3 Powering Up the System
To prevent an unwanted burst of noise from the speakers, power up the devices in the following
order: peripheral devices > mixing console > power amps (or powered speakers). Reverse this order to
power off. If you are using condenser microphones that require Phantom power, switch on before
turning on the power to the power amps or powered speakers.
10
Publicidad
