Mark MRACK 12E Manual Del Usuario página 7

10. MAIN(G1/G2)
This switch can switch the output signal of MAIN or GROUP to PHONES.
11. GROUP knob
- (GROUP 1-2) knob. For adjusting the level of the signals output to the (GROUP OUT 1,2) jacks.
- (TO MAIN) switch. If it is on, the signals are sent to the MAIN BUS via the (GROUP 1-2) knob.
12. MAIN(L-R)
For adjusting the level of the signals output to the MAIN OUT jack.
BUILT-IN EFFECTS AND MP3 BLOCK
1. DISPLAY
2. PROGRAM knob
To select an effect turn the knob
and press the knob to enable it.
3. PARAMETER knob
For adjusting (depth, speed...) for
the selected effect. The last value
used with each effect type is
saved.
4. FOOT SW jack
Connect a foot switch to this
input jack.
5. FX switch
This button turns the
corresponding effect on or off.
When the fuction is ON the
switch lights red.
6. MAIN switch
Turn this switch on to output the
signals of the built-in effect to
the MAIN buses.
7. G1-2 switch
Turns this switch on to output signals of the built-in effect to the GROUP 1-2 buses.
8. PFL switch
To output the built-in effect signals to the PFL buses, turn this switch on.
6