Wolder AUTOBIKE TECH X1 Manual De Instrucciones página 13

Fig. 1
!"#$%&67&43+8,&,"%&-./%&0#11.%1&38&,"%&1339&-#1:&
• Make sure the roof bars are properly installed on the car roof and the preferred distance between the two bars is
around 70cm
• Place the bike carrier in the middle of the roof bar as shown in Fig.2 (or Fig.3) if to mount one bike carrier for
carrying one bike. For multiple bike carriers, place them evenly across the roof bars, and make sure the total
weight does not exceed the capacity of the roof bars.
Installation on square bars:
• Fix the bike rack fitting the "U" screw (No. 3 of the list) under the bar making it entering from the bottom in the
proper holes situated on the plate.
•
Fit washer 6 (No. 4 of the list) inside the "U" screw and tighten firmly using knob A(No. 5 of the list).
• Repeat this on the other side of the plate. And also fix on the rear part of the bike rack the T-bolt(No.8 of the list)
in the proper profile (No.2 of the list) groove as shown in Fig.2.
• Fit the support slab (No.9 of the list) making it entering from the bottom, fit washers 6(No.4 of the list) and
tighten firmly using knobs (No. 5 of the list).