Wolder AUTOBIKE TECH X1 Manual De Instrucciones página 14

Fig. 2
Installation on oval bars with universal T-track:
•
Put the T-bolt (No.5 of the list) in the proper crossbar groove as shown in Fig.3, slide the T-bolt to the proper
place.
• Fit washer 6 (No.4 of the list) inside the T-bolt and tighten firmly with using knobs (No.7 of the list).
• Repeat this on the other side of the plate. And also fix on the rear part of the bike rack the T-bolt(No.8 of the list)
in the proper profile (No.2 of the list) groove as shown in Fig.3.
• Fit the support slab (No.9 of the list) making it entering from the bottom, fit washers 6(No.4 of the list) and
tighten firmly using knobs (No. 5 of the list).
Fig. 3