Bromic Heating PLATINUM SMART-HEAT Serie Instrucciones De Instalación página 12

WIRING DIAGRAM FOR LOW CLEARANCE CEILING RECESS KIT
2300W/3400W (FOR USE WITH DIMMER OR ON/OFF)
BELOW IS A SIMPLIFIED DIAGRAM OF THE TERMINAL BOX.
ALL CONNECTIONS ADJUSTED BY THE INSTALLER ARE DISPLAYED.
ITEMS NOT DISPLAYED SHALL NOT BE MODIFIED.
WARNING
AC Single Phase Heater
must be permanently
installed and hard wired
by an authorised/licensed
person.
This product is designed for use
with both 220-240V & 208V
Platinum Electric Heaters.
WIRES DENOTED
BY DASHED
LINES ARE
SUPPLIED BY
THE INSTALLER.
NOTES:
• For wiring instructions using Bromic SmartHeat Dimmer(s) or ON/OFF Controller(s) refer
to the instructions provided with the controller.
Non-self resetting
thermal switch
TOP VIEW OF
TERMINAL BOX
To Dimmer Power (Load) Output
To
OR ON/OFF Power (Load) Output
To Dimmer Power Supply Input To
OR ON/OFF Power Supply Input
S1
BROWN
LIVE/ACTIVE
OR HOT LEG 1
PHASE A
OR
PHASE B
OR
PHASE C
OR
bromic.com
S2
N2
L
N
SUPPLY
BLUE GREEN/YELLOW
NEUTRAL
HOT LEG 2
US ONLY
PHASE B
240V OR 208V
PHASE C
PHASE A
HEATER
CABLE
EARTH
12