Bromic Heating PLATINUM SMART-HEAT Serie Instrucciones De Instalación página 7

9. Remove the lid of the terminal box by removing
M4x8mm screws and set aside for re-
the 4x
assembly.
800mm (31.5") - 2300W
1000mm (39.3") - 3400W
1040mm (40.9") - 4500W
10. Cut down the heater cable no shorter than
800mm (31.5") for 2300W, 1000mm (39.3")
for 3400W or 1040mm (40.9") for 4500W
measured from the cable gland.
11. Feed the heater cable through the lower M16
(2300W/3400W) or M20 (4500W) cable gland
located on the terminal box. Ensure that the cable
gland is tightened.
12. Feed the mains (and control cables if
applicable) through the terminal box cut-out in
the heater box.
Refer to the wiring diagram diagrams on the next
page
For installs using a Bromic Dimmer (sold separately) OR
On/Off Controller (sold separately), please refer to the electrical diagram on page 11.
For installs using a manual wall switch (not supplied), please refer to the electrical diagram
on page 14.
Comprehensive electrical diagrams can be found on page 18.
bromic.com
7