Publicidad
Idiomas disponibles
Idiomas disponibles
1. The motor output shaft end bevel gear wheel transmission mesh:
（1）Check whether the size of bevel gear wheel is damaged;
（2） Check whether the meshing positions of the big and small bevel gears
wheel are correct, the adjustable small bevel gears wheel is rising to the
correct meshing position and tighten the hex screws on the gear( when the
small bevel gear wheel on the motor shaft position is moved down).
2. The damage of transmission cylindrical gear
(1) The size of transmission cylindrical gear is divided into a pair of large
cylindrical gear
(Z = 52), a pair of small cylindrical gear (Z = 39).
(2) Iron gear is generally is tooth form damage
(3) If the cylindrical gear transmission has abnormal sound, it can be
judged that the cylindrical gear is damaged, in the initial stage of the gear
damaged, the machine work must be stopped immediately, the damaged
gear must be replaced, otherwise it will affect the relative position of the
working parts of machine, thus aggravates the damage of the gear, and
until damage the electrical machine and the working surface of the and
concave and convex balls.
Replace the method of cylindrical gear:
A. Remove the damaged cylindrical gear and the elated parts according to
the assembly sequence
B. Use two square hole templates lock the upper two of four corner angle
shaft parallels( figure 1), and then install two big cylindrical gears
(figure1)
C. Remove the two square hole templates.
- 10 -
Publicidad
