Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
Selecting the Input Signal
This monitor has two signal input connectors (HD15 and
5BNC) and can be connected to two computers. When the
power of both computers is on, select the input signal you
want to view as follows.
1
Turn on the monitor and both computers.
2
Press the INPUT button to select the HD15 or 5BNC
input signal.
Each time you press the INPUT button, the input signal
and corresponding indicator alternate.
HD15 BNC
INPUT
Selecting the INPUT signal mode
This monitor has two modes of input signal selection,
"AUTO" and "MANUAL."
When "AUTO" is selected
If no signal is input from the selected connector, the monitor
automatically selects the other connector's signal. When you
restart the computer you want to view, or that computer is
in power saving mode, the monitor may automatically
select the other connector's signal. This is because the
monitor switches from the interrupted signal to the constant
signal. If this happens, manually select the desired signal
using the INPUT button.
When "MANUAL" is selected
Even if no signal is input from the selected connector, the
monitor does not select the other connector's signal.
1
Press the MENU button.
The MENU OSD appears.
MENU
8
MENU
OK
MENU
COLOR
CENTER
SCREEN
GEOM
EXIT
ZOOM
LANG
SIZE
OPTION
2
Press the ¨./> and >?// buttons to select "
OPTION," and press the MENU button again.
The OPTION OSD appears.
3
Press the ¨./> buttons to select "
4
Press the >?// buttons to select "AUTO" or
"MANUAL."
The OPTION OSD automatically disappears after about 30
seconds.
To close the OSD, press the MENU button again.
For more information on using the OSD, see "Introducing
the On-screen Display System" on page 9.
OPTION
ON
ZZ...
1 MIN
UNLOCK
MANUAL DEGAUSS
(INPUT)."
OPTION
AUTO
MANUAL
ZZ...
1 MIN
UNLOCK
INPUT
Publicidad
