Kripsol KS Evo VS 150 Manual Del Usuario página 27

4.5 Setting the Timer mode
The control panel allows you to program multiple sequences
(see section 2.3) or Timers t0 to t5, which do not need to follow a
chronological order.
Unused Timer settings will be deactivated.
Timer 't0' can be set to 00:00, 06:00 (by default), 12:00 or 18:00. It
cannot be deactivated.
You cannot adjust the speed of t0, it is set at 2400 rpm
• Identify the speed profile you would like to program.
The image opposite is shown as an example.
• Check whether the internal clock has been set correctly.
• Press and hold DISP/FUNC for 3 seconds
All 3 LEDs will blink and the screen will display
"ConF"
• Press DISP/FUNC twice and the screen will
display "t0"
• Press DISP/FUNC: the screen will display "06-00" -
this is the default value of t0
• Press the up / down buttons to set the value you
would like for t0 (00-00, 06-00, 12-00 or 18-00)
• Press DISP/FUNC: the screen will display "t1oFF"
• To activate this Timer setting (as an example),
press the 'up' button. The screen will display "t1
on"
• Press DISP/FUNC: the screen will display "00-00"
• Press the up / down buttons to set the desired
timetable (hh-mm)
• Press DISP/FUNC: the screen will display "0"
• Press the up / down buttons to display the desired
speed (600 to 3000 rpm or 0)
• To go to the next Timer setting, press DISP/FUNC:
the screen will display "t2off". In this example the
Timer setting stays deactivated
• Press DISP/FUNC to go to the next Timer setting
and repeat the steps (activation, timetable, Timer
setting and speed)
• Press RUN/STOP to exit and save
The display will show the current speed or StoP
27
USE ONLY KRIPSOL
>3s
x 2
GENUINE REPLACEMENT PARTS
®
Pump
t4
time
ConF
t0
06-00
18-00
t1off
t1 on
00-00
20-00
0
2740
t2off
t3off
etc ...
/
1640
t1
t0
t5
t3
(t2)
20-15
StoP