MZ electronic CC011 Instrucciones De Uso página 25

Installing the chain counter
(see connection diagram at the end of the manual)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO
INSTALLATION.
The chain counter must be positioned
so that the display will be easy to read. It
should not be exposed to direct sunlight.
The rear part of the instrument must be
protected from contact with water or
moisture.
Drill a hole with a diameter of 54 mm (2"
1/8) on the dashboard.
The dashboard thick-ness may not
exceed 20 mm
In the part to the rear of the dashboard
there must be minimum clearance of 70
mm (2" 6/8).
Secure the instrument in place with the
plastic ring
The plastic ring must be applied between the front of the dashboard panel and the
fastening bracket.
For instructions on making electrical connections, see the attached diagram. The wires
must have a minimum cross section size of 0.5 mm².
Install a 0.5 A (ampere) safety fuse on the + wire of the battery.
The instrument complies with EMC standards (EN55022) and must be positioned at a
distance of 0.5 metres (1.64 Ft) from radio receiver devices.
CC011
RING GASKET
25
English
PLASTIC RING
Rev. 01 – 2024