MZ electronic CC011 Instrucciones De Uso página 28

By pressing button C for a few seconds it is possible to enter the instrument setting menu
which presents all the available parameters in sequence one after the other.
CC011
Measure
Selects the unit of measurement:
•
Feet/ inches
•
Metres / centimetres
Wait a few seconds without pressing any
button to move to the next parameter.
Barbotin
The circumference of the gypsy must
be entered in this row (in centimeters or
inches). To enter the correct value see
the paragraph "instrument calibration"
Wait a few seconds without pressing any
button to move to the next parameter.
Divisor
If the standard 2-wire electronic sensor
(STD) is used, this value must be left at 1. if
an electronic sensor is used it must be equal
to the number of sensor pulses for each turn
of the barbotin. See paragraph "Instrument
calibration".
Wait a few seconds without pressing any
button to move to the next parameter.
28
English
Rev. 01 – 2024