Descargar Imprimir esta página

Craftsman 875.199530 Manual Del Propietário página 3

Herramienta neumática de corte

Publicidad

Idiomas disponibles

Idiomas disponibles

Branch line =2times
Tool inlet/hose
size
Auto Drain
Va Ive
_Auto
Drain
Valve
More than 1/100 slope
4_
Stop
Valve
Filter
Regulator
Lubricator
Air Tool
Figure1
Air Hose Hook Up
Main line = 3 times
Tool inlet/hose
size
Do Not Operate
Without
Guard
Always use cut-off wheels with an RPM rating that
meets or exceeds the tool RPM rating. Always
examine cut-off wheels for chips, cracks or signs of
damage before mounting. Never use cut-off wheels
that have been dropped or exposed to: water, solvent
or extreme temperatures.
It is a good practice to
operate the tool in a protected enclosure for one
minute after mounting a cut-off wheel.
WARNING:
DISCONNECT TOOL FROM AIR
SUPPLY BEFORE SERVICING OR CHANGING
DISCS.
PLEASE NOTE: USE ONLY CUT-OFF WHEELS
RATED AT OR ABOVE 20,000 RPM ONLY (SEARS
ACCESSORY 18834). THE CUT-OFF WHEEL MUST
HAVE A 3/8" CENTER HOLE. NEVER OPERATE
THIS TOOL IF GUARD IS BROKEN OR REMOVED.
Lubrication
An in-line filter-regulator-lubricator
(fig 1) is recommended
as it increases toot life and keeps the toot in sustained
operation. The in-line lubricator should be regularly
checked and filled with air toot oil. Proper adjustment of
the in-line lubricator is performed by placing a sheet of
paper next to the tools exhaust ports and holding the
throttle open approximately 30 seconds. The lubricator is
properly set when a light stain of oil collects on the paper.
Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for
an extended period of time (overnight, weekend, etc.), it
should receive a generous amount of lubrication through
the air inlet. The toot should be run for approximately 30
seconds to ensure oil has been evenly distributed
throughout the toot. The tool should be stored in a clean
and dry environment.
Recommended
lubricants:
Use air tool oil or any other
high grade turbine oil containing moisture absorbent, rust
inhibitors, metal wetting agents and an EP (extreme
pressure) additive.

Publicidad

loading