Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED (CONTINUED)
2. Align and slide the hook of the charging base onto the side notch at the bottom of the main body until it stops.
Make sure their contact plates are properly in contact.
3. Plug the jack of the external adaptor into the charging port at the end of the charging base.
4. Connect the external adaptor to the power source. Once the pool vacuum begins charging, the indicator light on the
external adaptor will turn red. Normally, it takes about 4- 5 hours to reach a full charge. The indicator light will turn
green when the pool vacuum is almost fully charged.
5. When charging is complete, disconnect the external adaptor from the power source then unplug the jack from the
charging base.
6. Detach the charger base from pool vacuum. Store charger base and external adapter in a cool dry place till next use.
NOTE:
•
In case, charging plates get wet, dry the area completely before charging.
•
Normally, the pool vacuum can be operated up to 30 minutes on a full charge (charged for 4-5 hours)
•
FACT: Rechargeable lithium-Ion battery is classified as a consumable item. It has a limited life and will gradually lose
its capacity to hold a charge. Therefore, running time of the pool vacuum will gradually reduce through repeated
charging and discharging in operation.
•
Let the pool vacuum rest for 30 to 40 minutes before charging it again.
ASSEMBLY
Suction head assembly
Insert the suction head directly into the suction mouth of the pool vacuum until the side tabs of the transparent case clip
in the holes of the suction head's pivot.
Note: For vinyl liner and fiberglass pools / spas, it is recommended to keep the brush on the flat nozzle to
avoid damaging the pool / spa.
5
Publicidad
