Descargar Imprimir esta página

Project Source RPV31-PS Manual De Instrucciones página 6

Aspiradora subacuática recargable para piscinas grandes y spas

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY (CONTINUED)
Telescopic pole connector assembly
1. Press down the side pins of the connector/handle. 2. Insert the pole connector inside the main body.
3. Turn the connector in either direction until the pin is secured in the hole 4. Pin will protrude through hole.
Telescopic pole (not included)
1. Press down on both side tabs.
3. Allow tabs to snap into side holes on pole.
To release the telescopic pole, press down on both the side tabs simultaneously, and then pull out the pole.
OPERATION
WARNING!
Do not use the pool vacuum if any damage is detected.
Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
Do not operate this pool vacuum if there are people/pets present in the water.
Make sure the pool vacuum is fully immersed in the water before initiating operation. The minimum water level
required to operate the device must reach above the power ON/OFF switch of the pool vacuum when it is held in a
vertical position. Operating the pool vacuum when not immersed in the water correctly can damage the unit and the
warranty will be voided as a result.
Maximum operating depth in water is 3 meters (10ft).
Maximum water temperature: 5˚C (41˚F) –35˚C (95˚F)
DO NOT use the pool vacuum without an intact filter cage in place. Using your pool vacuum without an intact filter
cage in place will VOID your warranty.
Suction entrapment hazard: This pool vacuum generates suction. Do not allow hair, body or any loose parts of your
clothing to contact the suction mouth of the pool vacuum during its operation.
Never insert body parts, clothing or other objects into the openings and moving parts.
DO NOT use this pool vacuum to pick up any toxic substance, flammable or combustible liquids such as gasoline, or
operate in the presence of explosive or flammable fumes.
DO NOT cover the side slot of the cleaner body during operation. The impeller/motor may be damaged as a result.
Never insert any object to touch the impeller.
2. Slide telescopic pole over pole connector/handle
6

Publicidad

loading

Este manual también es adecuado para:

5333329