Project Source RPV31-PS Manual De Instrucciones página 8

MAINTENANCE & STORAGE
1. Battery discharges on its own during storage. Make sure to charge the pool vacuum to about 30% to 50%
of the battery capacity before it is stored.
2. You must re-charge the battery at least once every three months when it is not in use.
• Unplug the external adaptor from socket and then unplug the adapter jack from the charging base.
• Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and accessories with fresh water.
DO NOT use detergent.
• Make sure to drain the water from the unit, handle and pole connector.
• Use a damp cloth to clean and dry the pool vacuum and its accessories.
• Store them in a well-ventilated area away from the sunlight, children, heat, ignition sources, and pool chemicals.
Ambient temperature for storage should be 10˚C – 25˚C (50˚F – 77˚F). NOTE: A higher temperature may reduce
the battery life during storage.
WARNING!
- Never attempt in any way to disassemble the pool vacuum.
- Under no circumstances should you attempt to disassemble the pool vacuum and replace the impeller, motor and battery.
CAUTION!
• Excessive heat can damage the battery and reduce its lifespan as a result.
• Consult your dealer regarding battery replacement if the following happens:
- Battery does not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times of the first few operations
(on a full charge). Use these run times as a reference point to compare with run times of older batteries.
• The battery must be removed from the pool vacuum before it is scrapped.
• The pool vacuum must be disconnected from the supply mains when removing the battery
• The battery is to be disposed safely and according to local ordinances or regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a result.
TROUBLESHOOTING
Problem Possible Cause
Battery is running out
Pool vacuum does
not capture debris
Impeller is jammed
Impeller is broken
Filter cage is full
Suction nozzle flap is
Debris escapes
broken
from the filter
Filter cage is
damaged.
Outlet valve comes off.
Debris is to fine
Pole connector
Side pin on pole
can't be secured.
connector is broken
Pool vacuum can Battery is damaged
not be charged /
recharged
Contact plates of the
charger base and unit
are not connected.
External adaptor
damaged
Pool vacuum does Wheel is jammed
not move smoothly
Solution
Charge the battery again.
Power off the pool vacuum and visually check the gap in the middle of the
pool vacuum to see if the impeller is jammed by large debris. If possible,
use a small tool to remove the debris carefully. WARNING! Make sure the
pool vacuum is powered off when the unit is being serviced.
Replace main body
Clean the filter cage.
Suction nozzle flap works like a door to prevent debris from escaping from
the filter. Replace nozzle flap
Replace with a new filter cage.
Without the outlet valve, the pool vacuum might capture debris through
this opening. Replace Transparent canister
Filter bag will not collect fine silt or algae less than 250 micron in size.
Replace with a new pole connector.
Replace main body WARNING! DO NOT open the pool vacuum and
replace the battery by yourself. This could result in severe or fatal injury
and the warranty will be voided as a result.
Make sure that the charger base is assembled on the unit properly and the
contact plates are connected.
Replace external adaptor WARNING! Using the wrong external adaptor
will result in damaging the pool vacuum / battery and voiding the warranty
as a result.
Clean out the debris from the wheel.
8
Printed in China