FITFIU FITNESS BESP-150 Manual De Usuario página 33

Assembly
Step by step
First, we are going to fix the front stabiliser (2) on the main body (1) using the carriage bolts (16),
flat washers (17) and cover nuts (18). Be sure to tighten them with an open-end spanner (25).
Remember that the front stabiliser movement wheels (2) must be facing forward as shown.
Likewise, the rear stabiliser (3) is attached to the main body (1) using the carriage bolts (16), flat
washers (17) and cover nuts (18), and also tightened with the open-end spanner (25). Note that
the movable wheels on the sides of the front stabiliser (2) allow the machine to be moved over
short distances.
01
02
Let's insert the saddle frame (4) into the
main body (1). Then, pull out the adjustment
knob (14) so that it is automatically inserted
into the corresponding hole of the frame (4).
Similarly, the handle post (5) is inserted into
the main body (1) and the adjustment knob
(14) is pulled out so that it automatically
inserts into the corresponding hole in
the handle post (5). If you need to adjust
the height of the saddle frame (4) or the
handle post (5), pull the adjustment knob
(14). After adjusting, be sure to tighten the
adjustment knob (14).
33
Now proceed to install the right pedal (12)
with the "r" mark on the main body (1),
securing it with the open-end spanner
(25). Turn it clockwise. Similarly, the left
pedal (13) with the "l" marking is placed on
the main body (1) and secured using the
open-end spanner (25). Remember to turn
it anticlockwise. The adjustment knobs
(14) are placed on the front and rear of the
main body (1) respectively. For now, it is not
necessary to tighten them.
03
4
14
EN - BESP-150
5
14
1