WolfPack DT2211 Manual De Instrucciones página 36

• Extension Cords and Reels
- The appliance should be supplied via a residual current device (RCD) with a tripping
current of no more than 30 mA.
- When the power tool is to be used outdoors, use only extension cords that are intended
for outdoor use and are so marked.
- Always unwind any extension cords fully.
- For extension cords up to 15 metres use a wire cross section of 1.5mm2.
- For extension cords over 15 metres but less than 40 metres use a wire cross section of
2.5mm2.
- Always replace a damaged extension cord before using it.
- Protect your extension cord from sharp objects, excessive heat and damp or wet
locations.
• Stay Alert
Preste atención a lo que hace, utilice el sentido común y no utilice la herramienta eléctrica
si está cansado, si está tomando medicamentos que causan somnolencia o si ha
consumido alcohol o drogas.
• Check Damaged Parts
Antes de utilizar las herramientas eléctricas, debe comprobarlas cuidadosamente para
asegurarse de que funcionan correctamente y cumplen la función prevista.
• Check for the correct alignment of moving parts, ensuring they do not bind. Check for
broken or missing parts and have them replaced or repaired at an authorised service
centre. Check any other condition that may affect the operation of the power tool.
• A guard or any other part of the power tool that is damaged should be properly
repaired or replaced by an authorised service centre unless otherwise indicated in this
instruction manual..
• Any switch that does not operate correctly must be replaced by an authorised
service centre. Do not use the power tool if the ON/OFF switch does not turn the power
tool ON and OFF.
WARNING! Do not attempt to modify the power tool in any way. The use
of any attachment or accessory over than those recommended in this
instruction manual could result in damaged to the power tool and injury
to the operator.
• Have your power tool repaired by a qualified person.
This electric power tool complies with national and international standards and safety
requirements. Repairs should only be carried out by qualified persons and using original
spare parts. Failure to do so may result in considerable danger to the user.
• Fire Precaution
When using certain power tools inside your house or workshop, general fire precautions
should be observed. As a precaution it is recommended that an expert be consulted on
36