i-box Awake Manual Del Usuario página 6

Before getting started
Before setup or making connections please extend the antenna fully.
OUTPUT 5V
Powering your Radio Alarm Clock
To power the i-box Awake alarm clock, plug the power adaptor (supplied) into a wall socket and the jack plug into the DC
In port on the back of the Awake (13).
DC IN 9V
OUTPUT 5V
Battery Backup Installation
1 x CR-2032 battery is installed in the battery compartment (24) to provide a backup power supply. If the mains supply
is disconnected or interrupted this backup power supply ensures that the time and alarm settings are saved but does not
power any other functions (e.g. Radio or display). Remove the plastic tab as shown below to activate the battery.
Setting the Clock
Long press the Volume + / Clock Key (9) to start setting the time manually.
Set the Time Display Format - 24 hour clock (military time) or 12 hour (AM/PM)
00:00
Set the Time - Hour and Minutes
00:00 13:00
Standby Mode and Mode Select
Long Press the Standby / Function Mode key (10) to enter Standby. Short press the Standby / Function Mode key
(10) to enter playback mode and select mode (FM or BT).
13:32
06 | Awake
DC IN 9V
24H 12H
13:00
FM
98.2
Replacing the battery
24H
13:32
BT
13:33
Help
Short Press
Long Press