Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
Packing
When you open the package, make sure that no
necessary parts are missing.
lf
any of these are
missing ar damaged, please contact your dealer:
- Remate Control
- User Manual
- Batteries
Remote Control
After reading the instructions
on this page regarding the
operation of your TV set and
the remate controller, you
can proceed to the other
pages that tell the use of
remate control and channel
setting
procedure.
To
replace
the
batteries,
open
the
battery
cover;
replace
the
batteries
[2x
AAA)
+
and - pales match the
directions in the battery compartment and then
clase the battery cover. Make sure you point the
remate control at the remate control receiver on the
TV.
CAUTION:--------~
- Do not use old and new batteries together,
otherwise the remole control may be damaged.
- Do not use rechargeable batteries.
- Do
not
expose
the
batteries
to
high
temperatures; do not throw in the tire, charge or
lay open. Otherwise this may cause effluence or
explosion.
- lf you are not going to use the remole control far
a long time, remove the batteries inside.
- lf the battery is replaced with a wrong type,
there is danger of explosion. Please replace only
with the same or equivalen! battery.
Television /
User Manual
9
EN
WatchingTV
- Plug the electric cable FIRST to the television, and
THEN
to the wall outlet. Location of the electric
socket at the back side of the TV can vary upan the
model.
- Your TV set can only be connected toan AC power
supply.
lt
must not be connected to a DC supply.
lf
the plug is departed from the electric cable, never
plug it into wall plug.
- Plug the exterior antenna cable ar cablevision
cable to the antenna/cable input socket al the back
of the TV set.
CAUTION: - - - - - - - - ~
- Antenna socket [75 Ohm - VHF/UHF/cable) can
be used far the connection of other devices (video
recording
device,
satellite
receiver,
etc)
connected with an exterior antenna or modulator.
We recommend not to connect other devices
(video recorder, satellite receiver, etc.) to your TV
set initially, as the installation procedure will get
more complicated dueto the additional steps. You
may connect these devices after finishing
channel adjustment.
- You can turn on your TV by pressing the On/Off
button.
N O T E : - - - - - - - - - - ~
- Befare connecting the other devices to AV
sockets, complete the channel adjustment to
avoid any problems about device selection.
- Unplug the power cord from the outlet befare
connecting any device to your TV. Otherwise, you
may cause your TV to malfunction.
Publicidad
