cecotec CONGA 7490 IMMORTAL X-TREME Manual De Instrucciones página 53

Please note
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
- This robot vacuum cleaner includes a package designed to protect it during transport. Take
the robot vacuum cleaner out of the box. Keep the original box and other elements in a safe
place, as this will help you prevent product damage when transporting it in the future. In
case the original packaging is disposed of, make sure all packaging materials are recycled
accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or not in good condition, immediately contact the official Cecotec Technical
Support Service.
Warnings
Remove all objects around the robot vacuum cleaner such as clothing, papers, cables,
-
curtains, or other fragile objects which may block or slow down the operation of the robot
vacuum cleaner. Fig. 4
If the room to be cleaned is near a balcony or stairs, a physical barrier should be placed to
-
prevent the robot vacuum cleaner from falling and getting damaged, thus ensuring safe
operation. Fig. 5
Do not use the robot vacuum cleaner for liquids. Fig. 6
-
- Direct exposure to sunlight or heavy light contrasts may affect the correct operation of
the sensors. If exposed, the robot vacuum cleaner will stop. Move it to another location to
start a new cleaning cycle.
- Please note that the total height of the robot vacuum cleaner is 9.3 cm and the sensors
are at the bottom, so it is advisable to prevent access to all areas below 9.3 cm to avoid
damaging the laser.
Installing the robot vacuum cleaner and charging base
1. Place the charging base against a wall and leave a minimum free space of 1.5 metres to the
front and 0.5 metre to each side. Fig. 7
2. Connect the charging base to a power socket. Wind and store the remaining cable to
prevent accidents.
3. Install the side brush. Fig. 8
4. Hold down the Start/Pause button for a few seconds.
5. When the indicator light turns on, place the robot vacuum cleaner in the charging base
and make sure the charging terminals on the robot match those of the charging base. If
the light is flashing blue, it means the battery is not completely charged. To ensure the
maximum cleaning time, wait until the light turns into steady blue, as this indicates that
the battery is fully charged and that the robot vacuum cleaner is ready to clean. Fig. 9
CONGA 7490 IMMORTAL X-TREME
ENGLISH
53