Descargar Imprimir esta página

HomeMatic IP HmIP-ESI-IEC Manual De Instalacion Y Uso página 21

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
Changing the batteries
7
Changing the batteries
If an empty battery is displayed in the
app or on the device
codes and flashing sequences" on page
23), replace the used batteries with
two new LR6/Mignon/AA batteries. You
must observe the correct battery po-
larity.
To replace the device batteries, please
proceed as follows:
• Remove the cover (B) to open the
battery compartment (F)
(see
illustrations).
(see „8.3 Error
• Remove the used batteries.
• Place the two new 1.5 V LR6/Mi-
gnon/AA batteries in the battery
compartment (F) in accordance
with the polarity markings.
• After inserting the batteries, pay
attention to the flashing sequen-
ces of the LED
and flashing sequences" on page
23).
• Put the cover (B) back onto the
mounted electronics unit (D), en-
suring that it latches fully into
place.
Once the batteries have been inserted,
the device will perform a self-test for
approx. 2 seconds. Afterwards, ini-
tialisation is carried out. The LED test
display will indicate that initialisation
is complete by lighting up orange and
green.
(see „8.3 Error codes
21

Publicidad

loading