Matikgate ULTRA Serie Manual Usuario/Instalador página 77

BASE MENU ADJUSTMENT
Press ENTER button shortly to enter the basic menu.
oL
appears on the display, with the UP/DOWN buttons it is possible to select other functions from this menu.
EH
To exit the menu, select
Shortly press ENTER
*The Sc menu only works if br
(barrier logic) is set to YS.
Exit
oL
OPERATING MODE
oc
Opening/Closing mode: input 3 is opening, input 4 is closing.
St
Step by step mode: input 3 is Start, input 4 is pedestrian.
EH
To exit this menu, select
So
OPENING DECELERATION
YS
Deceleration in the opening phase is enabled.
nt
Deceleration in the opening phase is disabled.
EH
To exit this menu, select
Sc
AVERAGE CLOSING SPEED
1
SD speed lower in the closing phase.
2
3
SD speed higher in the closing phase.
EH
To exit this menu, select
Lc
TRANSMITTERS LEARNING
c1
Select this menu and transmit to record a transmitter.
rA
Remove all codes (select
EH
To exit this menu, select
Lt
WORKING TIME LEARNING
Au
Automatic learning of working time.
Manual learning time. With the gate closed, leave the SD gate open (at this stage you can adjust the speed). When the gate closes, press
Mn
the ENTER button or command Open/Start to set the initial position of the SD.
EH
To exit this menu, select
or press UP and DOWN at the same time.
Operating mode
Opening deceleration
Average closing speed *
Transmitters learning
Working time learning
Pause time
(automatic closing)
Man present mode
EH
or press UP/DOWN at the same time.
EH
or press UP/DOWN at the same time.
EH
or press UP/DOWN at the same time.
YS
to confirm).
EH
or press UP/DOWN at the same time.
EH
or press UP/DOWN at the same time.
EN
DEFAULT
DEFAULT
DEFAULT
77
MATIKGATE AUTOMATION