Truma C30 Instrucciones De Funcionamiento página 19

Fault indicator
Please note that the fault indicator will always be green if normal. When flashing, it will
change to orange color.
Error code Number of
(Display) flashes (every
4 seconds)
E0
E1
Cause
- Broken temperature
sensor
Low voltage
1 Battery discharge
protection has been
triggered
Descripton / Solution
• When the LED display will show
E0, means NTC (the temperature
sensor) broken circuit or short
circuit. Please contact the Truma
Service Center for support.
• Try on different power source
(vehicle or 100 V - 240 V AC
connector). If changing power
source fixed issue, then possible
issue with original power source.
• Ensure cabling between ap-
pliance and battery is at least
1.5 mm² (AWG 15), if the dis-
tance is more than 2 meters use
at least 2.5 mm2 (AWG 13) cable.
• Reduce battery discharge protec-
tion (e.g. ME or LO)
19