Descargar Imprimir esta página

Husqvarna PW 350 Manual De Usuario página 24

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 147
To disengage the power trigger lockout, push the
button to the unlocked position.
To start the product
1. Connect the product to a water source. Refer to
connect the product to a water source on page 22 .
2. Connect the power plug to a power source.
3. Turn the power switch to the on (I) position. (Fig. 56)
4. Disengage the power trigger lockout. Refer to
engage and disengage the power trigger lockout on
page 23 .
5. Push the power trigger on the spray handle.
Note:
The product stops automatically when you
release the power trigger.
To stop the product
Note:
The product stops automatically when you
release the power trigger.
1. Release the power trigger on the spray handle.
2. Engage the power trigger lockout. Refer to
engage and disengage the power trigger lockout on
page 23 .
3. Turn the power switch to the off (0) position. (Fig. 57)
4. Disconnect the power plug from the power source.
5. Disconnect the product from the water source. Refer
To disconnect the product from the water source
to
on page 23 .
Note:
Always disconnect the product from the
water source if you go away from the product for
more than 5 minutes.
To adjust the angle of the spray handle
(PW 360, PW 370)
1. Push the button and turn the handle clockwise or
counterclockwise. (Fig. 58)
2. Release the button. The handle locks in position.
To use the foam sprayer (PW 350)
1. Remove the foam sprayer from its holder. (Fig. 59)
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
24
To
To
To
Maintenance
Before you do
2. Fill the container on the foam sprayer with cleaning
agent.
CAUTION:
agents that are recommended by
Husqvarna.
3. Push the quick connection on the foam sprayer into
the quick connection on the spray lance until it locks
in position. The flange on the foam sprayer must
align with the groove in the spray lance. (Fig. 60)
4. Connect the product to a water source. Refer to
connect the product to a water source on page 22 .
5. Start the product. Refer to
page 24 .
To use the foam sprayer (PW 360, PW
370)
1. Remove the foam sprayer from its holder. (Fig. 61)
2. Fill the container on the foam sprayer with cleaning
agent.
CAUTION:
agents that are recommended by
Husqvarna.
3. Push the coupling on the foam sprayer into the
spray handle. Turn the foam sprayer clockwise and
release the foam sprayer. The foam sprayer locks in
position. (Fig. 62)
4. Connect the product to a water source. Refer to
connect the product to a water source on page 22 .
5. Start the product. Refer to
page 24 .
6. Turn the knob on the foam sprayer to adjust how
much foam is used. Turn the knob clockwise to use
more foam. Turn the knob counterclockwise to use
less foam. (Fig. 63)
7. Turn the nozzle cover to adjust the foam spray
pattern. Turn the nozzle cover clockwise for a
smaller foam spray pattern or counterclockwise for
a wider foam spray pattern. (Fig. 64)
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing.
For more detailed information, refer to
www.husqvarna.com.
Use only cleaning
To
To start the product on
Use only cleaning
To
To start the product on
2167 - 004 - 18.12.2023

Publicidad

loading

Este manual también es adecuado para:

Pw 360Pw 370