Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance schedule
Maintenance
Do a general inspection. Refer to
Clean the product. Refer to
Clean the spray lance and the nozzles. Refer to
25 .
Clean the water filter. Replace the water filter if it is damaged. Refer to
the water filter on page 26 .
Lubricate the O-rings on the couplings. Refer to
couplings on page 26 .
Clean the filter in the foam sprayer.
To do a general inspection
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
•
Make sure that the nuts and the screws on the
product are tightened.
•
Make sure that the cables on the product are not in a
position where they can become damaged.
•
Examine the high-pressure hose for wear and
damage.
WARNING:
product if the high-pressure hose is worn
or damaged.
To clean the product
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
•
Clean all external parts with a dry cloth.
2167 - 004 - 18.12.2023
To do a general inspection on page 25 .
To clean the product on page 25 .
To clean the product on page
To lubricate the O-rings on the
Put the power switch in the
Disconnect the product from
Do not operate the
Put the power switch in the
Disconnect the product from
To clean
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air inlets clean to make sure that the
product always has sufficiently cool temperature.
To clean the spray lance and the nozzles (PW
350)
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source before you do maintenance
on the product.
1. If a nozzle is installed on the spray lance, remove it
from the spray lance. Refer to
page 21 .
2. Clean the nozzles, the coupling on the spray lance,
and the coupling on the spray handle with soap and
water. (Fig. 65)
3. If there is blockage in the nozzles, remove it with the
cleaning tool. (Fig. 66)
To clean the spray lance and the nozzles (PW
360, PW 370)
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source before you do maintenance
on the product.
Before
After use
use
storage
X
X
X
X
X
Put the power switch in the
Disconnect the product from
Nozzles (PW 350) on
Put the power switch in the
Disconnect the product from
Before
X
25
Publicidad
