Publicidad
Idiomas disponibles
Idiomas disponibles
Product Istructions:
Packing and Shipping
· When unpacking for inspection, it is necessary to remember the location of the packaging parts, and
after inspection, it is necessary to strictly pack the original packaging method before transportation.
· When moving and transporting, collision or violent vibration should be avoided, and the tilt Angle of the
product should not exceed 45 degrees to avoid damage to the refrigeration system components.
Placement
· Please remove the packaging foam before use.
· The ground where the product is placed should be flat and firm, so that the product is firmly placed, and
the compressor can work smoothly, and the product vibration and noise are reduced.
· Please do not place the product in direct sunlight or near heat sources,
a lso don't put it in a place
exposed to rain or in a damp place.
· The product should be placed in a dry place, otherwise it will affect its electrical insulation ability.
· In order to make the product better ventilation and heat dissipation, there should be at least 10cm gap
around the product.
· The wheels on the product are limited to short distance movement on flat ground only.
· Do not place the product in a cold and icy place.
First Test Running
· After the product is moved, it is best to put the power on after 30 minutes
· For the first test run, please turn the thermostat knob to the position you want. Because the temperature
in the freezer is high, the first test run can be stopped after a long period of time, and then the product
can be automatically switched on and off regularly.
It is recommended that customers place items in the freezer according to the freezing capacity indicated
by each type of product after automatic opening and shutdown when using the product for the first time.
Product Operation and Maintenance:
Defrosting
· With the decrease of the temperature in the freezer, the inner surface of the product will frost, and the
thickness of the frost layer will affect the refrigeration effect. When the thickness of the frost layer exceeds
5mm, it should be defrosted in time.
· Before defrosting, the thermostat knob can be adjusted to the frozen or quick-frozen file for a period of
time, so that the temperature of the frozen item can be lowered to facilitate storage.
· Cut off the power supply, remove frozen items, and take insulation measures.
· Open the door and remove with a defrosting shovel when the frost layer begins to melt.
· Pull out the drain plug at the bottom of the freezer and drain the defrosting water inside the freezer.
· Dry the inner wall, turn on the power, and put the frozen items back after 2 hours of power.
3/8
NOTE:
Do not use metal sharps such as iron
sheets and steel brushes during
defrosting to avoid damaging the inner
liner and evaporator.
Publicidad
