MSI IMMERSE GH50 WIRELESS Manual Del Usuario página 6

Setup
Wireless mode
ƒ Connect the Wireless USB Transmitter to the PC, and turn
on the headset.
ƒ The Transmitter Status Indicator will illuminate when the
Wireless USB Transmitter is plugged in.
‚ If the white light stays on: the headset is connected.
‚ If the white light flashes slowly: the headset is
disconnected.
‚ If the white light flashes quickly: the headset and the
transmitter are pairing.
Wired mode (3.5mm)
ƒ By plugging the 3.5mm audio cable into the port, the headset
will automatically power off and switch to wired mode.
Controls
Power Button
ƒ To power on: press and hold for 3 seconds.
ƒ To power off: press and hold for 2 seconds.
ƒ The Power Button will illuminate when the headset is turned
on:
‚ The white light stays on: the headset is connected to the
transmitter.
‚ The white light flashes slowly: the headset is
disconnected from the transmitter.
‚ The white light flashes quickly: the headset is pairing.
Mic Mute / Pairing Button
ƒ Press to mute the microphone. If the red light is on, the mic
is muted.
ƒ Press to unmute the microphone. If the red light is off, the
mic is not muted.
Volume Control
ƒ To turn up the volume: scroll up on the control wheel.
ƒ To turn down the volume: scroll down on the control wheel.
ƒ A beep will sound when the volume is adjusted to the
maximum or minimum.
Reset Button
ƒ To reset the headset: insert a pointed object such as a pin
into the hole and push the button. The headset will then be
forced to shutdown.
Power button, mic mute/pairing button, volume control, and reset button
are unavailable when the headset is in wired mode with a 3.5mm
connection.
4