Publicidad
Idiomas disponibles
Idiomas disponibles
Re-pairing
ƒ Press and hold the power button for 3 seconds to turn on
the headset.
ƒ Press and hold the mute button for 3 seconds until the white
light on the power button starts flashing quickly.
ƒ Connect the Wireless USB Transmitter to the PC until its
white light flashes slowly.
ƒ Insert a pointed object such as a pin into the hole on the
transmitter and push the button for 2 seconds until the white
light flashes quickly.
ƒ The headset will make a sound to indicate that pairing mode
has been entered.
ƒ When successfully paired, the white lights on the headset
and Wireless USB Transmitter will stay as a steady white
light.
Battery Life & Charging
ƒ To charge the headset: connect the USB-C cable to the
charging port and the other end to a power source.
ƒ Charging Status Indicator:
‚ When fully charged, the red light turns off.
‚ When charging, the red light breathes.
‚ When the battery is low, the red light flashes.
Important
1�
The maximum input voltage is 5.5V.
2�
Chargers labeled with 5V voltage and 500mA current
purchased from official channels are recommended.
3�
When the battery is exhausted, please recharge the
headset as soon as possible.
4�
It is recommended to fully charge the headset if it is not in
use for a long time.
5�
It is recommended to connect the microphone gently to
prevent damage to the connector.
6�
Please do not disassemble the product since it may cause
damages.
7�
It is recommended to install Nahimic for Headset to
enjoy the best experience with full functionality and
synchronization to the operating system.
5
Publicidad
