Connecting Speakers - Sherwood AX-5505 Manual De Instrucciones

AX5505(G-Eng)100204_AX5505(Eng).qxp 2010-02-23 오후 2:04 페이지 5

■CONNECTING SPEAKERS

• This amplifier enables you to listen to two pairs of speakers
individually or in various combinations.
Connect your main speakers to the SPEAKER A terminals and
use the SPEAKER B terminals for the remote pair located
elsewhere in your home.
• Be sure to connect speakers firmly and correctly according to the
channel (left and right) and the polarity (+ and -).
• Do not let the bare speaker wires touch each other or any metal
part of this unit. This could damage this unit and/or the speakers.
• Never touch the speaker terminals while the AC input cord is
connected to the wall AC outlet. Doing so could result in electric
shocks.
Note : For safe amplifier operation, use the speakers with
impedance of over 8Ω when you use either SPEAKER A or
B terminals and use the speakers with impedance of over
16Ω when you use both SPEAKER A and B terminals.
■AC INPUT CORD
Plug this cord into a wall AC outlet
■SWITCHED AC OUTLET
• This outlet is switched on (power on
mode) and off (standby mode)
according to power control as follows;
(Maximum total capacity is 100 W
(0.43A))
Standby mode - switched AC outlet off
Power on mode - switched AC outlet on
■Connecting speaker wire
1. Strip away approx. 10 mm (3/8 inch) of
wire insulation, then twist the wire ends
tight.
2. Loosen by turning the speaker
terminal counter-clockwise.
3. Insert the bare part of the wire.
4. Tighten by turning it clockwise.
5