Front Panel Controls - Sherwood AX-5505 Manual De Instrucciones

AX5505(G-Eng)100204_AX5505(Eng).qxp 2010-02-23 오후 2:04 페이지 6

Front Panel Controls

1. POWER SWITCH
Press this switch to enter the power off or the standby
mode.
2. STANDBY INDICATOR
In the standby mode, this indicator lights up.
3. SPEAKER SELECTOR A, B BUTTONS/
INDICATORS
Press the button to switch the desired speakers on
or off.
4. INPUT SELECTOR BUTTONS/INDICATORS
Press the button to select the desired input source.
• When the TAPE 2 MONITOR indicator lights up, other
inputs cannot be heard from the speakers.
To listen to an input source other than TAPE 2 MONITOR,
be sure to set the TAPE 2 MONITOR button to off.
5. VOLUME CONTROL KNOB
Adjust the volume to a comfortable listening level.
6. BASS CONTROL KNOB
Adjust the low-frequency tone.
• The center position is the flat (normal) condition.
7. TREBLE CONTROL KNOB
Adjust the high-frequency tone.
• The center position is the flat (normal) condition.
8. BALANCE CONTROL KNOB
Adjust the stereo balance between left and right
speakers.
• The center position is the normal condition.
9. TONE DIRECT SWITCH
Press this switch to bypass the tone (bass and treble)
circuitry for pure sound.
10. LOUDNESS SWITCH
Press this switch to emphasize the sound of frequencies
that are difficult to hear at low volume levels.
• The frequency emphasis varies according to the volume
level at which you are listening.
11. HEADPHONE JACK
Stereo headphones with a standard 1/4 inch plug can be
plugged into this jack for private listening.
• When listening with headphones, turn off both
SPEAKER SELECTOR A and B buttons.
12. REMOTE SENSOR
This receives the signals from the system remote control
unit.
6