Ibiza Light E-BEEDREAM100 Manual De Instrucciones página 4

• Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse
size and type.
• Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its carry-
ing handles.
• Maximum ambient temperature (Ta) is 35°C. Do not operate the fixture at temperatures higher than this.
• The surface temperature of the unit may reach up to 120°C. DO NOT TOUCH the housing barehand during its
operation. Turn off the power and allow about 15 minutes for the unit to cool down before replacing or servic-
ing.
• DO NOT OPEN the unit within 5 minutes after switching off.
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the near-
est authorized technical assistance center. Always use the same type of spare parts.
• Don't connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on.
• The product is for decorative purposes only and not suitable as a household room illumination.
• The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded.
• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit
is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can
hold 12 times the weight of the unit when installing the fixture.
Never stand directly below the device when mounting, removing or servicing the fixture. This fixture may be
mounted in any position provided there is adequate room for ventilation.
The LED moving head provides a unique mounting bracket assembly that integrates the bottom of the base, the
included 'omega bracket' and the safety cable rigging point in one unit.When mounting this fixture on a truss, be
sure to use an appropriate clamp with the included omega bracket using a M10 screw fitted through the center
hole of the 'omega bracket'. As an added safety measure, be sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable rigging points integrated in the base assembly.
FUSE REPLACEMENT
• With a flat head screwdriver wedge the fuse holder out of its housing.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
• Insert the fuse holder back in its place and reconnect power.
• The fuse is located inside this compartment. Remove using a flat head screwdriver.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Console Light1
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended seri-
al data link distance: 100 meters. Maximum recommended number of fixtures on a serial data link: 32 fixtures
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
4
MANUAL - E-BEEDREAM100
Light2 Light3
Code: 16-2108