Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9
PELLET USE
9.1
LOADING PELLET FUEL
d
It is forbidden to use any fuel other than pellets.
l
Before proceeding with the operations described be-
low, consult the chapter "Fuel".
To load the pellets:
- open the cover of the pellet tank (1)
- introduce the pellets into the tank (2) and close the cover of the
pallet tank.
a
If the cover of the pellet tank is not closed or is
closed incorrectly, the proper oxygenation or opera-
tion of the appliance may not be guaranteed. The ap-
pliance will enter the alarm mode, consult the chap-
ter
"Alarm signals, causes and possible
l
The appliance will generate more noise if the pellet
container is empty. We therefore recommend always
keeping the pellet tank filled to at least half-way.
9.2
CONTROL PANEL ON THE APPLIANCE
The appliance is equipped with a control panel (1) that allows for man-
aging the appliance's basic functions without the remote control, that is:
- switching the appliance on or off
- modifying the working power.
20
1
2
Fig. 15
remedies".
1
Fig. 16
Shown below are the instruments of the control panel and their relat-
ed functions.
1
2
3
4
5
Description
Status
(1)
RECEPTION
Lit
LED
(2)
Lit
ALARM LED
(3) and (4)
LED 3 Off, LED 4 Lit
POWER
LED 3 Lit, LED 4 Lit
STATUS
LED 3 Lit, LED 4 Off
LEDs
Off
(5)
Flashing
ON/OFF LED
Lit
Off
Slow flashing
(6)
WI-FI LED
Fast flashing
Lit
COMMISSIONING AND USE
6
8
9
7
Fig. 17
Action
Switches on when the PCB
receives a signal from the
remote control.
The appliance is in alarm
mode.
Set output on 1.
Set output on 3.
Set output on 5.
The appliance is off.
The appliance is switching
off.
The appliance is on.
The appliance is not
connected to a Wi-Fi
network.
The Wi-Fi module is
in Access Point mode
(awaiting connection to the
network).
The Wi-Fi module is in WPS
mode (signal search).
The appliance is connected
to a Wi-Fi network.
CS.DLA.IST_EN_Rev. 1.0_11-23
Publicidad
