Parkside PTPK 400 B1 Traduccion Del Manual De Instrucciones Originales página 26

GB MT
In the case of stationary installation,
check regularly (no less then once
every three months) that the fl oat
switch (5) is working.
The On/Off switch point of the fl oat switch
(5) is infi nitely variable:
You can vary the switch-on and switch-off
point by:
- adjust the position of the fl oat switch
height adjustment (6) on the fl oat switch
guide (8).
- varying the length of the fl oat switch ca-
ble (7). Push/pull the cable (7) through
the eye on the retaining clip (6) for this.
Check the
fl oat switch (5).
- It must be positioned so that it can lift
and lower freely. The switching point
heights "On" and "Off" must be easy
to reach.
Check this by placing the pump into a
vessel fi lled with water and lift the fl oat
switch (5) carefully by hand and then
lower it again. In this case, you can
see whether the pump switches on and
off.
- Make sure that the distance between
the fl oat switch (5) and the fl oat switch
height adjustment (6) is not too short.
If the distance is too short, the device
may not work properly.
- During the adjustment of the fl oat
switch (5), ensure that the fl oat switch
does not contact the fl oor before the
pump switches off.
There is a risk of dry running if
the fl oat switch cable (7) is set too
long, especially if the fl oat switch
height adjustment (6) is not fi tted
(see "Start up").
26
Manual mode/fl at
suction
Caution: Avoid dry running
of the pump! Danger of over-
heating!
Never touch an overheated
pump! There is a danger of
burns!
In manual mode, the pump does not switch
off automatically, as the fl oat switch (5) is
bypassed.
The fl oat switch (5) must be positioned ver-
tically upwards on the pump for this.
Slide the fl oat switch height adjustment (6)
over the fl oat switch guide (8) next to the
handle (1).
Pull the fl oat switch cable (7) through the
fl oat switch height adjustment (6), until
the fl oat switch (5) is positioned vertically
above the height adjustment (6). See illus-
tration .
Monitor the pump constantly when
in manual mode. Switch the pump
off immediately (disconnect from the mains)
if no more water is being pumped. There is
a risk of damage if the pump runs dry.
Maintenance and
Cleaning
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.
There is a risk of injury!