Auping Iris Manual De Instrucciones página 14

3. Put the lead of the Iris bed lamp through
the support. Note: start from the inside.
4. Assemble the Iris bedlamp. Position the Iris
bedlamp vertically. Turn the Allen screws
using the Allen key.
GB4
2765 BW.pdf - pag.12
It is not possible to adjust the position of the
Iris bed light forward or backwards. However,
the overhang of the Iris bed light can be adjust-
ed inwards or outwards. By unscrewing the
upper two Allen screws and tightening the bot-
tom screw, the lamp will lean towards the bed.
If the bottom screw is unscrewed and the top
Allen screws tightened, the Iris bed light will
move outwards, away from the bed.
3.2 Mounting on flat boxspring
Mount the clamp onto the Iris bed light by
using the 2 supplied Allen screws.
fig. 4
Mount the entire lamp onto the frame by slid-
ing the clamp over the frame.
Fasten the lamp using the 2 pointed screws.
It is not possible to adjust the position of the
Iris bed light forward or backwards. However,
the overhang of the Iris bed light can be adjust-
ed inwards or outwards. By unscrewing the
upper two Allen screws and tightening the bot-
fig. 5
tom screw, the lamp will lean towards the bed.
If the bottom screw is unscrewed and the top
Allen keys tightened, the Iris bed light will
move outwards, away from the bed.
LET OP !!! Lage resolutie!
fig. 6
April 13, 2007