Publicidad
Idiomas disponibles
Idiomas disponibles
FIXTURE PACKING LIST
Description
A Light Fixture.......................................................................... 1
B Buttons to choose color and dusk to dawn on/off ................ 2
C C Mounting bracket (pre-installed)
Mounting bracket (pre-installed) .......................................... 1
D 3"
3" Center Mounting screw (pre-installed)
Center Mounting screw (pre-installed) ............................ 1
E 3/4" #6, #8 & #10 Mounting Screws*.................................... 6
F Wire Nuts*
Wire Nuts* ............................................................................ 3
G Rubber Plug*
Rubber Plug* ....................................................................... 1
*Contained in parts packs
Remove fixture components and parts pack. Check to ensure
all parts are included. Note: Account for small parts and destroy
packing material, as these may be hazardous to children.
1. SELECT MOUNTING LOCATION
This fixture is intended for installation to properly installed
and grounded UL listed round recessed or surface mounted
weatherproof junction box.
Suitable for wall mount above 4ft (1,2m) from ground.
Do NOT install Nearby large, light-colored objects, reflecting light
may trigger the shut-off feature. Do not point other lights at the
daylight sensor.
Turn OFF Power at fuse or circuit breaker box!
CAUTION: Do not rely on wall switch alone to turn off power.
Connect fixture to a 120 Volt, 60Hz power source.
2. INSTALL MOUNTING BRACKET TO JUNCTION BOX
• Loosen the center mounting screw (D) and remove the
mounting bracket. Note: Center mounting screw and bracket are
pre-installed on the light fixture for shipping.
• Install the mounting bracket (C) to the junction box using two
3/4" mounting screws (E). Note: Choose one of the 3 screw
sizes provided depending on your junction box.
3. CAUTION: WIRING
Make sure power is turned off.
• Use wire nut to connect the bare copper or green house
supply ground wire to the green fixture ground wire. Note: If
house wiring does not include a ground wire, consult your local
electrical code for approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
• Use wire nut to connect the white fixture wire to the white
(neutral) house supply wire.
• Use wire nut to connect the back fixture wire to the black house
supply wire.
4. FIXTURE INSTALLATION
• Tuck wires into junction box
• Align fixture over j-box and secure to mounting bracket by
tightening center mounting screw (D). Note: Make sure no wires
are pinched before tightening.
• Insert rubber plug (G) into center hole to cover the center
mounting screw head for moisture seal.
Quantity
See Fig. A.
INSTALLATION INSTRUCTIONS
Daylight sensor
D
G
urn on electricity at fuse or circuit breaker box and verify success
T
of installation.
Note: The Dusk to Dawn function is factory set in OFF position
to allow the fixture light to turn on during daytime for testing.
After testing push button to set in ON postion for Dusk to Dawn
operation. Note: there is a 4 second delay!
This Fixture allows you to choose your light color. Push button to
cycle through warm/3000K, cool/4000K and daylight/5000K. See
Fig. B
5. MOISTURE SEAL
Apply silicone caulking (not included) around the perimeter of the
fixture back where it contacts the mounting surface for moisture
page 3
A
B
F
C
E
Figure B
Figure A
Publicidad
