Lincat CiBO Instrucciones De Instalacion Y Uso página 32

Firmware control
Display Firmware Version – shows the current version of the Display Firmware
Control Firmware Version – shows the current version of the Control Firmware
Hardware Revision – shows the installed hardware Revision
VFD Firmware Version – Shows the current VFD Version.
Updates will be issued by Lincat when there is an enhancement to be made to the
oven.
The general sequence is to always update the display hardware first.
Update Display Firmware – Ensure the USB stick is inserted into the port behind the
lower air grill. Touch the arrow. This takes you to a confirmation screen, touch to
confirm and select the version of the software. This will then install and restart the
oven. Remove the USB stick, fit the dust cap and replace the grill
Update Control Firmware - Ensure the USB stick is inserted into the port behind the
lower air grill. Touch the Arrow. This takes you to a confirmation screen, touch to
confirm and select the version of the software. This will then install and restart the
oven. Remove the USB stick, fit the dust cap and replace the grill.
When updating software avoid opening closing the door as this may create
interference that slows the update process.
IS 782 ECN 5060 Page 32 of 182