Nolangroup N-Com R Serie Seguridad E Instrucciones página 41

9. BATTERY AND RECHARGE
9.1. Low battery signal
During its operation, the system provides the user with an audible alert when the battery is low. From
the first alert, the system has one hour of user time. A warning is given every 10 minutes.
9.2. Checking the Battery Level
When the system is powering on, the blue LED flashes rapidly indicating the battery level.
4 flashes = High, 75 ~ 100%
9.3. Charging the system
Fig. 30
The charge will take place as follows:
B101 system When the B101 system is connected to the battery charger, the blue LED starts to flash
turned off quickly. When the battery is charged, the blue LED becomes steady.
B101 system When the B101 system is connected to the battery charger, the blue LED starts to flash
turned on quickly. When the battery is charged, the blue LED goes back to its standard flashing.
N.B.: In case you are not planning on using the N-Com system for a long time, you need to fully
recharge the device before storing it away.
N.B.: In case the device is not used for a long time, carry out a complete recharging cycle of the device
at least once every 6 months to avoid possible damage to the battery.
N.B.: In case the N-Com system is left for more than 6 months without ever being recharged, the
device may not switch on; in this case, recharge the N-Com system for at least 24 hours (even if the
blue signalling LED is not flashing), then try to switch on the device again.
3 flashes = Medium, 50 ~ 75%
To charge the system, connect the system to a
charger or USB plug using the USB-C cable
supplied.
2 flashes = Low, 1 ~ 50%
17