Publicidad
IMPORTANT STUFF FOR PARENTS & KIDS
Keep these instructions in a handy location.
They contain important safety information.
Read all warnings and instructions before you
start to build and operate the model.
W RNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
CAUTION: Be careful not to tip the
model over. Model should be placed on
a flat and hard surface.
•
Product and colors may vary.
•
Be sure to install batteries into
the motor before you start building
the motorized models.
•
Take your time to enjoy the building
process. Don't rush!
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
•
Share the K'NEX experience with your
child and make building with K'NEX a
family fun adventure.
•
While you're building make sure you
face your model in the same
direction as the pictures show in
the instructions.
CONTENTS
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . .
Building Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SAWBLADE THRILL RIDE . . . . 4
BONUS IDEA . . . . . . . . . . . . 37
BATTERY INFORMATION
CAUTION: To Avoid Battery
Leakage
•
Be sure to insert the batteries correctly
and always follow the toy and battery
manufacturers' instructions.
•
Do not mix old and new batteries
or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium)
batteries. Only batteries of the same or
equivalent type recommended should
be used.
•
Always remove weak or dead
batteries from the product; do not
short-circuit supply terminals.
•
Insert batteries with correct polarity
(+/-) as shown.
Important Tips
•
Alkaline batteries AA (LR6) are
recommended.
•
Rechargeable batteries are not
recommended.
•
Remove rechargeable batteries from
toy before charging; they must be
charged only under adult supervision.
•
Non-rechargeable batteries must not
be recharged.
2
3
•
Keep components free of dust; do not
immerse or use in water.
•
Do not dispose of batteries in a fire;
they could leak or explode and cause
injury.
•
Remove all batteries if the toy will not
be used for a long period of time.
•
Do not put Rods smaller than
2 inches in any openings of the motor;
they will damage the motor, and cannot
be removed.
How to Insert and Remove
Batteries
•
Use a small screwdriver or coin to
open the battery pack cover. Insert
2 fresh AA batteries (LR6) into the
compartment with the correct
polarity (+/-).
Publicidad
