Software Upgrade Via Ftp; Reset And Factory Defaults - Leviton Luma-Net LumaCAN Manual Del Usuario

Command Prompt
C:\
Microsoft Windows XP [Version 5.1.26001]
(C) Copyright 1985-2001 Microsoft Corp.
C:\Documents and Settings\qms>cd\temp\gate
C:\Temp\gate>ftp 192.168.90.150
Connected to 192.168.90.150.
220 Service ready for new user
User (192.168.90.150: (none)): admin
331 User name okay. need password.
Password:
230 User logged in, proceed.
ftp> dir
200 Command okay.
150 File status okay: about to open data connection.
drw-rw-rw-
drw-rw-rw-
-rw-rw-rw-
226 Closing data connection.
ftp: 181 bytes received in 0.08Seconds 2.32Kbytes/sec.
ftp> get config.cfg
200 Command okay.
150 File status okay: about to open data connection.
226 Closing data connection.
ftp: 1084 bytes received in 0.06Seconds 17.48Kbytes/sec.
ftp> bye
221 Service closing control connection.
C:\Temp\gate>dir
Volume in drive C has no label.
Volume Serial Number is C481-BCA9
Directory of C:\Temp\gate
06/15/2011
06/15/2011
06/15/2011
C:\Temp\gate>
Via SD Card
1.
2. Copy and paste the configuration file to a specified location.
3. Replace the SD card into the Gateway.

5. SOFTWARE UPGRADE VIA FTP

Open a command prompt window
1.
2.
display (example shown in Figure 2
3.
4. Enter user name: admin
5. Enter password: password
6. Enter the DIR command
7.
8.
9.
10.
11. Restart the device.

6. RESET AND FACTORY DEFAULTS

FIGURE 5
1 user group 0 feb 26 2011 .
1 user group 0 feb 26 2011 . .
1 user group 1084 may
10:48 AM <DIR>
10:48 AM <DIR>
02:50 PM 1,084 config.cfg
1 Files(s)
1,084 bytes
2 Dir(s) 26,159,448,064 bytes free
Page 8
4 2001 confi.cfg
X